SparkFun 16x2 SerLCD RGB Text Qwiic 3.3V Logic

SparkFun 16x2 SerLCD RGB Text Qwiic 3.3V Logic

28,50 € (Net 23,95 €)

incl. 19% VAT , plus (M)

Choose tax zone / country of delivery

pcs

Product customisation & sourcing & PCBA one-stop service are available with us.

Request personal offer!

Orderable, information on delivery time as follows, otherwise please enquire.
Delivery time: 11 - 13 Workdays (Other countries)

SKU: SF16397
GTIN: 4060137081064
Category: LCD/TFT
Manufacturers: SparkFun
MPN: LCD-16397
Storage Tiers: Neu

The SparkFun SerLCD is an AVR-based, serial enabled LCD that provides a simple and cost effective solution for adding a 16x2 RGB on Black Liquid Crystal Display into your project. We've seriously overhauled the PCB design on the back of the screen by including an ATmega328P that handles all of the screen control, meaning a backpack is no longer needed! This display can now communicate in three different ways: serial, I2C, and SPI. This comes equipped with a Qwiic connector, bringing serial LCDs into the Qwiic ecosystem. This simplifies the number of wires needed and allows your project to display all kinds of text and numbers.

The on-board ATmega328P AVR microcontroller utilizes 11.0592 MHz crystal for greater communication accuracy with adjustable baud rates of 1200 through 1000000 but is default set at 9600. The firmware for this SerLCD is fully opensource and allows for any customizations you may need.

Note: Since the SerLCD is a 3.3V device, please make sure you convert to 3.3V logic depending on your chosen microcontroller or single board computer. Otherwise, you may risk damaging your board.

Features:

16x2, RGB on Black Display
The AVR ATMega328p (with Arduino-compatible bootloader) is populated on the back of each LCD screen and handles all of the LCD control
Three communication options: Serial, I2C and SPI
Adjustable I2C address controlled via software special commands (0x72 default)
Qwiic connection
Emergency reset to factory settings (Jumper RX to GND on bootup)
Operational backspace character
Incoming buffer stores up to 80 characters
Pulse width modulation of backlight allows direct control of backlight brightness and current consumption
Pulse width modulation of contrast allows for software defined contrast amount.
User definable splash screen
Open-sourced firmware and Arduino-compatible bootloader enables updates via the Arduino IDE
Dimensions (LxWxH): 80.02x36.13x14.27mm
Weight: 0.0779 oz.

Storage Tiers:	Neu
Resolution:	16x2
Form/Type:	LCD/TFT
Interface/Connector:	I2C
Touchscreen:	Non-Touch
Shipping weight:	0,10 kg
Item weight:	0,08 kg
Dimensions ( Length × Width × Height ):	8,10 × 3,80 × 1,50 cm