Pololu Stepper Motor NEMA 23 Unipolar Bipolar 200 Steps/Rev 57x56mm 3.6V 2A/Phase

Pololu Stepper Motor NEMA 23 Unipolar Bipolar 200 Steps/Rev 57x56mm 3.6V 2A/Phase

Dieser NEMA 23 hybrid Schrittmotor kann unipolar oder bipolar betrieben werden und hat einen Schrittwinkel von 1.8° (200 Schritt pro Umdrehung). Jede Phase hat ein Strom von 2 A bei 3.6 V, Dies ermöglicht einen Haltedrehmoment von 9 kg-cm (125 oz-in).

66,45 € (Net 55,84 € )

In stock

incl. 19% VAT , plus (XL)

Choose tax zone / country of delivery

pack

Product customisation & sourcing & PCBA one-stop service are available with us.

Request personal offer!

Available immediately
Delivery time: 6 - 8 Workdays (DE - int. shipments may differ)

SKU: PO1473
GTIN: 4060137018398
Category: Stepper Motors
Manufacturers: Pololu
MPN: 1473
Storage Tiers: Maintain

This NEMA 23-size hybrid stepping motor can be used as a unipolar or bipolar stepper motor and has a 1.8° step angle (200 steps/revolution). Each phase draws 2 A at 3.6 V, allowing for a holding torque of 9 kg-cm (125 oz-in).

This high-torque hybrid stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 1 A at 7.4 V, allowing for a holding torque of 9 kg-cm (125 oz-in). The motor has six color-coded wires terminated with bare leads that allow it to be controlled by both unipolar and bipolar stepper motor drivers. When used with a unipolar stepper motor driver, all six leads are used. When used with a bipolar stepper motor driver, the center-tap yellow and white wires can be left disconnected (the red-blue pair gives access to one coil and the black-green pair gives access to the other coil). We recommend using it as a bipolar stepper motor and controlling it with one of our bipolar stepper motor drivers or one of our Tic Stepper Motor Controllers. In particular, the Tics make control easy because they support six different interfaces (USB, TTL serial, I²C, RC, analog voltages, and quadrature encoder) and are configurable over USB with our free configuration utility.

Size: 56.4 mm square × 56 mm, not including the shaft (NEMA 23)
Weight: 0.7 kg (25 oz)
Shaft diameter: 6.35 mm (0.25″) “D”
Steps per revolution: 200
Current rating: 2 A per coil
Voltage rating: 3.6 V
Resistance: 1.8 Ω per coil
Holding torque: 9 kg-cm (125 oz-in)
Inductance: 2.5 mH per coil
Number of leads: 6
Lead length: 30 cm (12″)
Output shaft supported by two ball bearings