Pilot Rd. 920
Nevada
Las Vegas, Vereinigte Staaten, 89119
[email protected]
https://www.pololu.com/
Am Ostbahnhof 3
Niedersachsen
Clausthal-Zellerfeld, Deutschland, 38678
[email protected]
https://eckstein-shop.de
GTIN: | 4060137015144 |
HAN: | 2128 |
Category: | Stepper Motor Driver |
Storage Tiers: | Maintain |
Shipping weight: | 0,01 kg |
Item weight: | 0,00 kg |
Dimensions ( Length × Width × Height ): | 2,00 × 1,50 × 0,30 cm |
Overview
This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2 A output current per coil (see the Power Dissipation Considerations section below for more information). Here are some of the driver’s key features:
- Simple step and direction control interface
- Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step
- Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
- Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
- Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection
- Short-to-ground and shorted-load protection
- 4-layer, 2 oz copper PCB for improved heat dissipation
- Exposed solderable ground pad below the driver IC on the bottom of the PCB
This product ships with all surface-mount components—including the A4988 driver IC—installed as shown in the product picture.
Dimensions
- Size:0.6? × 0.8?
- Weight:1.5 g1
General specifications
- Minimum operating voltage:8 V
- Maximum operating voltage:35 V
- Continuous current per phase:1.2 A2
- Maximum current per phase:2 A3
- Minimum logic voltage:3 V
- Maximum logic voltage:5.5 V
- Microstep resolutions:full, 1/2, 1/4, 1/8, and 1/16
- Reverse voltage protection?:N
- Bulk packaged?:N
- Header pins soldered?:N4
Notes:
- 1. Without included optional headers.
- 2. Without a heat sink or forced air flow.
- 3. With sufficient additional cooling.
- 4. Male header pins are included for the board's 16 holes, but they are not installed.
Bedienungsanleitung
Manufacturer according to GPSR
Pololu Corporation, Pilot Rd. 920, 89119 Las Vegas, Nevada, Vereinigte Staaten, [email protected], https://www.pololu.com/
Responsible person according to GPSR
Eckstein GmbH, Am Ostbahnhof 3, 38678 Clausthal-Zellerfeld, Niedersachsen, Deutschland, [email protected], https://eckstein-shop.de