-
show more tabs
- Description
- Reviews (1)
This hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 500 mA at 10 V, allowing for a holding torque of 1kg-cm (14 oz-in). The motor has four color-coded wires terminated with bare leads: black and green connect to one coil; red and blue connect to the other. These leads connect to the stepper motor through a removable JST-ZHR-5 connector.
The motor can be controlled by a pair of suitable H-bridges (one for each coil), but we recommend using a bipolar stepper motor driver or one of our Tic Stepper Motor Controllers. In particular, the Tics make control easy because they support six different interfaces (USB, TTL serial, I²C, RC, analog voltages, and quadrature encoder) and are configurable over USB with our free configuration utility.
- Size: 35 mm square × 28 mm, not including the shaft (NEMA 14)
- Weight: 140 g (5 oz)
- Shaft diameter: 5 mm “D”
- Steps per revolution: 200
- Current rating: 500 mA per coil
- Voltage rating: 10 V
- Resistance: 20 Ω per coil
- Holding torque: 1 kg-cm (14 oz-in)
- Inductance: 13.5 mH per coil
- Lead length: 30 cm (12″)
- Output shaft supported by two ball bearings
General specifications
- Shaft type: 5 mm "D"
- Current rating: 500 mA, Per coil.
- Voltage rating: 10 V
- Holding torque: 14 oz·in
- Steps per revolution: 200
- Resistance: 20 Ohm, Per coil.
- Inductance per phase: 13.5 mH
- Number of leads: 4
- Lead length: 30 cm
- NEMA size: 14
Technical documents / Downloads
1Pololu Corporation, Pilot Rd. 920, 89119 Las Vegas, Nevada, Vereinigte Staaten, [email protected], https://www.pololu.com/