Overview
WaveShare Servo Driver HAT (B) for Raspberry Pi 16-Channel 12-bit I2C Right Angle Pinheader
Raspberry Pi is powerful enough in most cases, yet it's not that good at providing precise PWM output. You may have tried to control a robotic arm or a hexapod walker by using the Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, we prepare this useful Servo Driver HAT for you.
Servo Driver HAT (B): right angle pinheader, make it possible to connect servos even when stacking up. This HAT can be used to drive servos such as: SG90 Servo, MG90S Servo, MG996R Servo.
Specification
- Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
- I2C controlled, using only 2 pins
- Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales)
- Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal
- Standard servo interface, supports commonly used servo such as SG90, MG90S, MG996R, etc.
- Reserved I2C control pins, allows to work with other control boards
- Comes with development resources and manual (examples in python like Bluetooth/WiFi remote control).
- Power supply: 5V (Pi connector) OR 6V~12V (VIN terminal)
- Servo voltage: 5V
- Logic voltage: 3.3V
- Driver: PCA9685
- Control interface: I2C
- Dimension: 65mm x 30mm
- Mounting hole size: 3.0mm
Package includes
1x Servo Driver HAT (B)
2x RPI screws
Waveshare International Limited, World Trade Plaza south side, Fuhong Rd, Futian District, 518000 Shenzhen, China, [email protected], https://waveshare.com/