The new MKS Base V1.2 3D Printer Controller board combines and improves the assets of the RAMPS 1.4 and Aduino Mega 2560 boards on a fantastic single board solution.
The MKS GEN1.2 is an optimal 3D printer controller solution for your Reprap 3D Printer.
Features
The MKS GEN V1.2 solves interface connection problems between the Aduino Mega 2560 and RAMPS 1.4 boards by having both integrated into a single board
5 Stepper Motor Driver Slots. The boards supports a wide variety of Stepper Motor Drivers - most notably A4988, 8825 and Ice-Blue Stepper Motor drivers drive
The MKS GEN V1.2 board uses a high quality 4-layer PCB which optimizes heat dissipation
Firmware can use the same configuration as RAMPS 1.4
Easy DISPLAY + SD CARD connector - compatible pin header on board for 2864 & 2004 LCD Display controller panels.
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
By selecting "Accept all", you give us permission to use the following services on our website: Strictly necessary cookies, YouTube, Vimeo, Google Map, PayPal Express Checkout und Ratenzahlung, Google Kundenrezensionen, GoAffPro Affiliate Tracking, Google Analytics 4, Google Ads Conversion Tracking. You can change the settings at any time (fingerprint icon in the bottom left corner). For further details, please see Individual configuration and our Privacy notice.
The settings you specify here are stored in the "local storage" of your device. The settings will be remembered for the next time you visit our online shop. You can change these settings at any time (fingerprint icon in the bottom left corner).
For more information on cookie lifetime and required essential cookies, please see the Privacy notice.
Would you like to see these contents? Activate the desired contents for one session only or allow the website to remember these settings. Once you have given your consent, the third-party data can be loaded. For this, third-party cookies might be stored on your device. You can change these settings at any time (fingerprint icon in the bottom left corner). For further details, please see the Privacy notice.