This product uses the boost IC and high-power MOS, high efficiency (96%), wide voltage output, output power up to 65W (when the input and output voltage are above 20V). Applications such as 3.7V battery boost up to 5V for mobile power, 7.4V/12V boost up to 18V for lapto, etc.
The on-board voltmeter can measure the value of input voltage and output voltage, "IN" -Indicator for measuring the input voltage, "OUT" light for measuring the output voltage voltage.
Spezification
- Input Voltage: 3-35V DC (Note:When input voltage is less than 4V, onboard voltmeter will not work.)
- Input Current: 9A (max)
- Output Voltage: 3.5-35V DC(this board is boosting board, output voltage must >= Input voltage)
- Output Current: 6A (max)
- Output Power: 65W (when the input and output voltage greater than 20V, can boost up to 100W)
- Conversion Efficiency: max. 96%
- Output Ripple: 40mV(TYP)
- Onboard Voltmeter Range: 4-40V Tolerance +/-0.1V
- Size: 67.5x43x14mm
Note: No reverse connection protection, please pay attention to see the positive and negative electrode
- IN+: Input positive
- IN-: Input negative
- OUT+: Output positive
- OUT-: Output negative
Instruction:
-
Short press : switch the input/output voltage display.
- "IN" indicator is to measure the input voltage
- "OUT" indicator is to measure the output voltage.
-
Long press:
- for more than 1s and less than 4s, the voltmeter will be closed .
- for more than 4s, to enter the voltage accuracy calibration function , the "IN" and "OUT" indicator will synchronous flashing. Use the Touch button to adjust the voltage accuracy. long press the button for 2s to exit the calibration mode. The settings will be saved even when power off.
Note: This function is used to calibrate the voltage accuracy, not to adjust the voltage value of the output. This function is designed to meet your higher accuracy requirements, you only need to calibrate once to get the accurate value on the whole range.
Warm tip: When the high power load is connected, because the shock current of the start-up is very limited, it is recommended to start up and then connect the load.
FAQ:
1. Can it output 35V at 6A?
No,it can not.The output max is 100W. Only 75W for stable operation.
2. Can it meet : input 12V and output 5V?
No,it can not.It is boost module. The output must higher then input
Packagelist
- 1x DC-DC 100W Step-up Spannungsregler 3-35V to 3,5V-35V LED Voltmeter Power Modul
