World Trade Plaza south side, Fuhong Rd, Futian District
Shenzhen, China, 518000
[email protected]
https://waveshare.com/
Am Ostbahnhof 3
Niedersachsen
Clausthal-Zellerfeld, Deutschland, 38678
[email protected]
https://eckstein-shop.de
GTIN: | 4060137087523 |
HAN: | 19287 |
Category: | Board |
Shipping weight: | 0,08 kg |
Item weight: | 0,07 kg |
Dimensions ( Length × Width × Height ): | 6,70 × 5,30 × 2,00 cm |
ATMEGA328P microcontroller development board, Arduino-compatible R3 PLUS MCU development board
based on ATMEGA328P-AU
- Operating voltage 5V/3.3V. Dual voltage level to support more shields
- Reset Lateral. Lateral button is easier to use when connecting with shield
- Bootloader switch Yes. The board can be configured to run program immediately when power-up by the switch
- USB connector Micro USB. Micro connector is more commonly used, and shields won't be blocked anymore while connecting
- DC jack Low profile. Shields won't be blocked anymore while connecting
- Power output header Yes. Providing 5V/3.3V power output OR common-grounding with other boards
- 3.3V power output 800mA Max. R3 PLUS features higher driving capability
- Oscillator Crystal oscillator. suit for applications where accurate clock reference is required
- ADC channel 8. CFG used as ADC6 by configuration, and ADC7 from the Reserved PIN
- USB driver Compatible with all main systems. Driver will never failed to install thanks to the onboard FT232
- Firmware fixing Supported. Firmware can be fixed by using the onboard FT232, no extra programmer is needed Connecting with Waveshare Shields
What's On Board
- ATMEGA328P-AU
- AMS1117-3.3 3.3V voltage regulator
- NCP1117ST50T3G5V voltage regulator
- FT232RLUSB to UART convertor
- Arduino interfacecompatible with standard Arduino interface with two additional analog inputs A6 (config the CFG), A7
- ICSP interface
- MICRO USB connectorfor uploading program OR serial port debugging
- Power output header3.3V OR 5V, voltage level configured by the onboard power configuration switch, used as power output OR common-grounding with other boards
- FT232 pinsfor burning Bootloader into the microcontroller
- DC input7V ~ 12V
- Reset button
- Power indicator
- Serial port Rx/Tx indicator
- User LED
- 500mA fast auto-recovery fuse
- Power configurationfor configuring the operating voltage
-
Bootloader selection switch
- turn ON: the board will reset when power-up OR other USB devices were detected connecting to the PC
- turn OFF: the onboard program runs immediately when power-up, and the board will not reset when other USB devices were detected connecting to the PC
Wiki: www.waveshare.com/wiki/R3_PLUS
Lieferumfang
- R3-PLUS x1
- USB-A to micro-B cable x1
R3 Plus Wiki
Manufacturer according to GPSR
Waveshare International Limited, World Trade Plaza south side, Fuhong Rd, Futian District, 518000 Shenzhen, China, [email protected], https://waveshare.com/
Responsible person according to GPSR
Eckstein GmbH, Am Ostbahnhof 3, 38678 Clausthal-Zellerfeld, Niedersachsen, Deutschland, [email protected], https://eckstein-shop.de