Waveshare 0.96 inch 128x64 OLED SPI/I2C Interfaces vertical pinheader SSD1306

Item number: WS41006

SKU: 0.96inch OLED (B)

Category: Displays


6,77 €

including 19% VAT.,

Available now!

Shipping time: 1 - 3 workdays



Description

0.96inch OLED, SPI/I2C interfaces, straight/vertical pinheader

Key Parameters

Driver Chip SSD1306
Interface 3-wire SPI, 4-wire SPI, I2C
Resolution 128*64
Display Size 0.96inch
Colors Yellow, Blue
Visible Angle >160°
Dimension 33mm*33.50mm
Operating Temp. (?) -20~70
Storage Temp. (?) -30~80

Interface

PIN NO. SYMBOL DESCRIPTION
1 VCC Power positive (3.3~5V power input)
2 GND Ground
3 NC NC
4 DIN Data input
5 CLK Clock signal input
6 CS Chip selection, low active
7 D/C Command signal, low level for command, high level for data
8 RES Reset signal, low active

Hardware Config

Mode/Interface BS0/BS1 DIN SCK
3-wire SPI 1/0 MOSI SCLK
4-wire SPI 0/0
I2C 0/1 SDA SCL

Ordering Info

The 0.96inch OLED provides 2 options for the onboard pinheader:

  • 0.96inch OLED (A): curved/horizontal pinheader
  • 0.96inch OLED (B): straight/vertical pinheader

Downloads

Development resources: demo codes, schematic, datasheets, etc.
Wiki: www.waveshare.com/wiki/0.96inch_OLED_(B)

Dimension





Lieferumfang

Weight: 0.005 kg

  1. 0.96inch OLED (B) x 1





 


Ratings (1)

Average product review

4 Stars
3 Stars
2 Stars
1 Star

Share your experience with other customers:

5 from 5 Works perfectly controlled by an ATMEGA328P

As shown in this screenshot...

https://www.thanassis.space/IMG_20161119_182304.jpg

...the screen works fine over the SPI pins of an ATMEGA328P.
Connections:

DIN => Pin 17 (Arduino pin 11, MOSI/PWM, B3)
CLK => Pin 19 (Arduino pin 13, SCK, B5)
CS => Pin 16 (Arduino pin 10, PWM, B2)
D/C => Pin 15 (Arduino pin 9, B1)
Reset => Pin 14 (Arduino pin 8, B0)

Also of note - as shown in the picture, the SPI pins (19,18,17) can be used at the same time to program the ATMEGA328P from a Raspberry PI. There is no conflict there, since the pins are used as input during programming and become output (controlling the SSD1306) afterwards.

Very pleased with the result - nice screen.

., 19.11.2016

Question on item

Question on item