The Terminal Block Breakout FeatherWing kit is like the Golden Eagle of prototyping FeatherWings (eg. majestic, powerful, good-looking). To start, you get a nice prototyping area undeeath your Feather, with extra pads for ground, 3.3V and SDA/SCL. Not one to stop there, we expanded the PCB out to 2" x 2.5" with 3.5mm pitch terminal blocks down each side. There's also four mounting holes so you can attach the breakout to your enclosure or project.
This product works with all our Feathers! The terminal blocks allow you to coect to any of the exteal Feather pins, great for wiring temporary or permanent installations. We also give you a few extra terminal block pins for ground and 3.3V coections since those are so useful.
Finally, there's a spot for soldering in a slide switch. This coect the EN pin to ground when in the 'off' position, cutting off the 3.3V regulator. Note that the FONA Feather uses both VBat and 3.3V as power supplies so you wont be able to fully tu off the FONA Feather with this switch.
Comes as a kit with a nice PCB, socket headers, terminal blocks, and a slide switch. Soldering is required to assemble the Terminal Block Breakout FeatherWing, but it's not too tough if you've got a soldering iron and some basic hand tools.
1x Terminal Block Breakout FeatherWing Kit for all Feather Boards