Ready to plug & play It can connect to various modules like sensors, servos, relays, buttons and potentiometers.
Each functional module has buckled port with VCC, GND and Output, which has corresponding port on the Sensor Shield, connected with a plain 2.54mm dual-female cable you may start playing already.
Buckled brick cables are like cement for bricks, make the connections easier, secure and more professional looking.
You will need the following to use the Sensor Shield:
Arduino Uno R3 Board
Support IIC interface
Support 32 road Servo Motor Drive Shield interface
Support bluetooth module communication interface
Support SD card module communication interface
Support APC220 wireless rf modules communication interface
Support RB URF ultrasonic sensors interface
Support LCD serial and parallel interface
Size: 5.7cm X 5.7cm
1x Sensor Shield V5
Development resources: demo codes, schematic, datasheets, etc.
Click here to download