Pololu DRV8833 Dual Motortreiber Carrier

Item number: PO2130

This tiny breakout board for TIs DRV8833 dual motor driver can deliver 1.2A per channel continuously (2A peak) to a pair of DC motors. With an operating voltage range from 2.7V to 10.8?V and built-in protection against reverse-voltage, under-voltage, over-current, and over-temperature, this driver is a great solution for powering small, low-voltage motors.

Category: DC Motor Driver


4,87 €

including 19% VAT.,

Available now!

Shipping time: 1 - 3 workdays



Description

Overview

Texas Instruments? DRV8833 is a dual H-bridge motor driver IC that can be used for bidirectional control of two brushed DC motors at 2.7 V to 10.8 V. It can supply up to about 1.2 A per channel continuously and can tolerate peak currents up to 2 A per channel for a few seconds, making it an ideal driver for small motors that run on relatively low voltages. Since this board is a carrier for the DRV8833, we recommend careful reading of the DRV8833 datasheet (1MB pdf). The board ships populated with SMD components, including the DRV8833, and adds a FET for reverse battery protection.

This board is very similar to our DRV8835 dual motor driver carrier in operating voltage range and continuous current rating, but the DRV8835 has a lower minimum operating voltage, offers an extra control interface mode, and is 0.1? smaller in each dimension; we also carry a DRV8835 dual motor driver shield that is easy to use with an Arduino. The DRV8833 has a higher peak current rating (2 A per channel vs 1.5 A), optional built-in current-limiting, and no need for externally supplied logic voltage.

For a smaller, lower-cost, single-channel alternative to this driver, please consider our DRV8838 carrier, which offers a similar operating voltage range and current capabilities.

For higher-voltage alternatives to this driver, consider our A4990 and DRV8801 motor driver carriers.

Features

  • Dual-H-bridge motor driver: can drive two DC motors or one bipolar stepper motor
  • Operating voltage: 2.7?? V to 10.8 V
  • Output current: 1.2 A continuous (2 A peak) per motor
  • Motor outputs can be paralleled to deliver 2.4 A continuous (4 A peak) to a single motor
  • Inputs are 3V- and 5V-compatible
  • Under-voltage lockout and protection against over-current and over-temperature
  • Reverse-voltage protection circuit
  • Current limiting can be enabled by adding sense resistors (not included)

Ratings (0)

Average product review

Write your first review and help others with their purchase decision:


Other customers have also bought the following items
Pololu DRV8835 Dual Motortreiber Carrier Pololu DRV8835 Dual Motortreiber Carrier
50 ordered, expected on 10.03.2021
Pololu DRV8838 Single Brushed DC Motor Driver Carrier Pololu DRV8838 Single Brushed DC Motor Driver Carrier
Available now!
LiPo Akku Lithium-Ion Polymer Batterie 3,7V 2000mAh... LiPo Akku Lithium-Ion Polymer Batterie 3,7V 2000mAh...
Available now!
HC-SR04 Abstandsmessung Ultraschall Ultrasonic Sensor Module HC-SR04 Abstandsmessung Ultraschall Ultrasonic Sensor Module
Available now!
Jumper Wire 10x1P female to male 20cm Jumper Wire 10x1P female to male 20cm
Available now!
Pololu TB6612FNG Dual Motortreiber Carrier Pololu TB6612FNG Dual Motortreiber Carrier
Available now!