Pololu 5V, 2.5A Step-Down Spannungsregler D24V22F5

Artikelnummer: PO2858

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 36V and efficiently reduces it to 5V. The board measures only 0.7"x0.7" yet delivers a typical continuous output current of up to 2.5A and features reverse voltage protection. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors. An optional shutdown pin enables a low-power state with a current draw of around 20µA to 350µA, depending on the input voltage, and a power-good output indicates when the regulator cannot adequately maintain the output voltage.

Kategorie: Spannungsregler


8,94 €

inkl. 19% USt.,

5 bestellt, am 25.07.2017 erwartet

Lieferzeit: 5 bis 6 Tage



Beschreibung

Überblick

The D24V22Fx family of step-down voltage regulators generates lower output voltages from input voltages as high as 36 V. They are synchronous switching regulators (also called switched-mode power supplies (SMPS) or DC-to-DC converters) with typical efficiencies of 85% to 95%, which is much more efficient than linear voltage regulators, especially when the difference between the input and output voltage is large. These regulators can typically support continuous output currents of over 2 A, though the actual available output current is a function of the input voltage and efficiency (see the Typical efficiency and output current section below). In general, the available output current is a little higher for the lower-voltage versions than it is for the higher-voltage versions, and it decreases as the input voltage increases.

These regulators have a typical quiescent (no load) current draw of around 1 mA, and an enable pin can be used to put the boards in a low-power state that reduces the quiescent current to approximately 5 µA to 10 µA per volt on VIN.

The modules have built-in reverse-voltage protection, short-circuit protection, a thermal shutdown feature that helps prevent damage from overheating, and a soft-start feature that reduces inrush current.

The different voltage versions of this regulator all look very similar, so you should consider adding your own distinguishing marks or labels if you will be working simultaneously with multiple versions. This product page applies to all versions of the D24V22Fx family.

The D24V22Fx family is intended to replace our older D24V25Fx family of step-down voltage regulators. The two designs have the same size and similar current capabilities and input voltage ranges, but they do not have the same pinout and are based on different internal circuits, so there are fundamental differences in operation. In particular, these newer D24V22Fx regulators have much lower dropout voltages and provide a "power good" signal, and the newer design allows for higher output voltages (e.g. 12 V).

Eigenschaften

  • Input voltage:
    • 4 V to 36 V for the version that outputs 3.3 V
    • [output voltage + dropout voltage] to 36 V for output voltages of 5 V and higher (see below for more information on dropout voltage)
  • Fixed 3.3 V, 5 V, 6 V, 7.5 V, 9 V, or 12 V output (depending on regulator version) with 4% accuracy
  • Typical maximum continuous output current: >2 A
  • Typical efficiency of 85% to 95%, depending on input voltage, output voltage, and load
  • Switching frequency: ~400 kHz
  • Integrated reverse-voltage protection, over-current protection, over-temperature shutoff, and soft-start
  • 1 mA typical no-load quiescent current; this can be reduced to approximately 5 µA to 10 µA per volt on VIN by disabling the board
  • "Power good" output indicates when the regulator cannot adequately maintain the output voltage
  • Compact size: 0.7" × 0.7" × 0.31" (17.8 mm × 17.8 mm × 8 mm)
  • Two 0.086? mounting holes for #2 or M2 screws

Using the Regulator

Bewertungen (0)

Durchschnittliche Artikelbewertung

Geben Sie die erste Bewertung für diesen Artikel ab und helfen Sie Anderen bei der Kaufenscheidung:

Frage zum Produkt

Kontaktdaten
Frage zum Produkt
max. 500 Zeichen

ähnliche Produkte:
Pololu 12V, 2.2A Step-Down Spannungsregler D24V22F12 Pololu 12V, 2.2A Step-Down Spannungsregler D24V22F12
sofort verfügbar
Pololu 3.3V, 2.6A Step-Down Spannungsregler D24V22F3 Pololu 3.3V, 2.6A Step-Down Spannungsregler D24V22F3
sofort verfügbar
Pololu 6V, 2.5A Step-Down Spannungsregler D24V22F6 Pololu 6V, 2.5A Step-Down Spannungsregler D24V22F6
sofort verfügbar
Pololu 7.5V, 2.4A Step-Down Spannungsregler D24V22F7 Pololu 7.5V, 2.4A Step-Down Spannungsregler D24V22F7
sofort verfügbar
Pololu 9V, 2.3A Step-Down Spannungsregler D24V22F9 Pololu 9V, 2.3A Step-Down Spannungsregler D24V22F9
sofort verfügbar
Pololu Mini Pushbutton Power Switch with Reverse Voltage... Pololu Mini Pushbutton Power Switch with Reverse Voltage...
sofort verfügbar
Pololu Mini Pushbutton Power Switch with Reverse Voltage... Pololu Mini Pushbutton Power Switch with Reverse Voltage...
sofort verfügbar
Diese Modul passt zu folgende Produkten:
Pololu Rocker Switch: 3-Pin, SPDT, 10A Pololu Rocker Switch: 3-Pin, SPDT, 10A
sofort verfügbar
Pololu Toggle Switch: 3-Pin, SPDT, 5A Pololu Toggle Switch: 3-Pin, SPDT, 5A
sofort verfügbar
Kunden kauften dazu folgende Produkte
Jumper Wire 10x1P female to male 20cm Jumper Wire 10x1P female to male 20cm
sofort verfügbar
Pololu 5V, 5A Step-Down Spannungsregler D24V50F5 Pololu 5V, 5A Step-Down Spannungsregler D24V50F5
sofort verfügbar
Adafruit 8-channel Bi-directional Logic Level Converter Adafruit 8-channel Bi-directional Logic Level Converter
sofort verfügbar
Pololu 9V, 2.3A Step-Down Spannungsregler D24V22F9 Pololu 9V, 2.3A Step-Down Spannungsregler D24V22F9
sofort verfügbar
V-Tec Netzteil 12V DC 2.5A Power Adapter 5.5×2.1x10mm... V-Tec Netzteil 12V DC 2.5A Power Adapter 5.5×2.1x10mm...
sofort verfügbar
Pololu 5V, 1A Step-Down Spannungsregler D24V10F5 Pololu 5V, 1A Step-Down Spannungsregler D24V10F5
sofort verfügbar