Keyestudio Turbidity Sensor V1.0 With Wires Compatible with Arduino for Water Testing

Artikelnummer: SE01045

EAN: 4060137102226

HAN: KS0414

Herkunftsland: CN

TARIC-Code: 9031808000

Kategorie: Module


12,32 €

inkl. 16% USt.,

sofort verfügbar

Lieferfrist: ca. 1 - 2 Tage

Pack


Beschreibung

Introduction

This sensor is mainly used to test the water?s turbidity.

The principle is to convert the current signal into the voltage output through the circuit.

Its detection range is 0%-3.5% (0-4550NTU) , with an error range of ±05%F*S.

When using, measure the voltage value of sensor?s Signal end; then work out the water?s turbidity by simple calculation formula.

Note: the sensor is not water-proof; can only place the transparent part into water.

  • Input Voltage: 3.3 ~ 5.5V
  • Output Voltage: 0 ~ 2.3V
  • Working Current: 3 ~ 6mA
  • TDS Measurement Range: 0 ~ 1000ppm
  • TDS Measurement Accuracy: ± 10% F.S. (25 ?)

Bewertungen (0)

Durchschnittliche Artikelbewertung

Geben Sie die erste Bewertung für diesen Artikel ab und helfen Sie Anderen bei der Kaufenscheidung:


Kunden kauften dazu folgende Produkte
Pololu 3.3V, 600mA Step-Down Voltage Regulator D36V6F3... Pololu 3.3V, 600mA Step-Down Voltage Regulator D36V6F3...
sofort verfügbar
0.1 (2.54mm) Crimp Connector Housing: 1x3-Pin 25-Pack 0.1 (2.54mm) Crimp Connector Housing: 1x3-Pin 25-Pack
sofort verfügbar
2,54mm Dupont Jumper Crimp Connector Housing Stecker...
sofort verfügbar
Makeblock Nut 4mm(50-Pack)
sofort verfügbar
0.1 (2.54mm) Crimp Connector Housing: 1x6-Pin 10-Pack 0.1 (2.54mm) Crimp Connector Housing: 1x6-Pin 10-Pack
sofort verfügbar
Jumper Wire 10x1P female to male 20cm Jumper Wire 10x1P female to male 20cm
sofort verfügbar