DHT11 Digitaler Temperatur- und Feuchtigkeitssensor
Beschreibung
Übersicht
The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.
Compared to the DHT22, this sensor is less precise, less accurate and works in a smaller range of temperature/humidity, but its smaller and less expensive.
Technical Details
The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.
Compared to the DHT22, this sensor is less precise, less accurate and works in a smaller range of temperature/humidity, but its smaller and less expensive.
Technical Details
- Low cost
- 3,3to 5,5V power and I/O
- 2.5mA max current use during conversion (while requesting data)
- Good for 20-95% humidity readings with 5% accuracy
- Good for 0-50°C temperature readings ±2°C accuracy
- No more than 1 Hz sampling rate (once every second)
- Body size 15.5mm x 12mm x 5.5mm
- 4 pins with 0.1" spacing
The sensor protocol and timing is similar to the DHT22 so check out the DHT22 datasheet for more information
Arduino library and example code
Detailed usage tutorial
Lieferumfang
1x DHT11digital temperature and humidity sensor
Bewertungen (0)
Durchschnittliche Artikelbewertung
Frage zum Produkt
Kunden kauften dazu folgende Produkte
Uno R3 ATmega328P Board ATmega16U2 mit USB Kabel , Arduino Uno R3 kompatibel
7,99 € *
Alter Preis:
8,99 €