DC-DC Step-up Spannungsregler 100W 3-35V to 3,5V-35V mit LED-Voltmeter Power Module

Spezifikation

• Input Voltage: 3-35V DC (Note:When input voltage is less than 4V, onboard voltmeter will not work.)
• Input Current: 9A (max)
• Output Voltage: 3.5-35V DC(this board is boosting board, output voltage>=Input voltage)
• Output Current: 6A (max)
• Output Power: 65W (when the input and output voltage greater than 20V up to 100W)
• Conversion Efficiency: 96% (the highest)
• Output Ripple: 40mV(TYP)
• Onboard Voltmeter Range: 4-40V 
• Error: +/-0.1V
• Input reverse protection: No (One diode can be connected in series by yourself if need protection)
• Short circuit protection: Yes (limit current 14A).
• Size: 67x43x12mm

Note: No reverse connection protection, please pay attention to see the positive and negative electrode

• IN+ Input positive electrode
• IN-  Input negative electrode
• OUT+ Output positive electrode
• OUT-  Output negative electrode

1. Connect load at OUT+ and OUT- at first. Please note the positive and negative.
2. Connect power supply at IN+ and IN-. Please note the positive and negative.
3. Press the button to switch the display input or output voltage value.

Warm tip: When the high power load is connected, because the shock current of the start-up is very limited, it is recommended to start up and then connect the load.

Testing: