Adafruit Silicon MEMS Microphone Breakout - SPW2430, Range 100Hz - 10KHz

Adafruit Silicon MEMS Microphone Breakout - SPW2430, Range 100Hz - 10KHz

6,95 € (Net 5,84 € )

Top

incl. 19% VAT , plus (S)

Choose tax zone / country of delivery

pack

Product customisation & sourcing & PCBA one-stop service are available with us.

Request personal offer!

Must be ordered. Ready for shipment in 26 days after order.
Delivery time: 27 - 29 Workdays (DE - int. shipments may differ)

SKU: AF2716
GTIN: 4060137035791
Category: Sound sensor
Manufacturers: Adafruit
MPN: 2716
Storage Tiers: Maintain

Description
Reviews

We now have a breakout board for a super tiny MEMS microphone. Just like 'classic' electret microphones, MEMS mics can detect sound and convert it to voltage, but they don't need a bias resistor or amplifier, its all in one! The SPW2430 is a small, low cost MEMS mic with a range of 100Hz - 10KHz, good for just about all general audio recording/detection.

This breakout is best used for projects such as voice changers, audio recording/sampling, and audio-reactive projects that use FFT. To keep the breakout small and simple, we only added a 3V voltage regulator (the microphone requires 3.3V DC) and filter capacitors. No additional opamp is included, the output peak-to-peak voltage has a 0.67V DC bias and about 100mVpp (peak-to-peak) when talking near the microphone, which is good for attaching to something that expects 'line level' input without clipping. The peak-to-peak can be as high as 1Vpp if there's a very loud sound. If you are If you need a microphone with adjustable gain or auto-gain control, check out our mic+amplifier options. If you need a higher peak-to-peak, a rail-to-rail op-amp and some resistors can get you boosted up!

Using it is simple: connect GND to ground, Vin to 3.3-5VDC. For the best performance, use the "quietest" supply available (on an Arduino, this would be the 3.3V supply). The audio waveform will come out of the DC pin. The output will have a DC bias of 0.67V so when its perfectly quiet that's what you'll read, there's a little drift. If the audio equipment you're using requires AC coupled audio, you can grab the signal out of the AC pin, which has a 10uF capacitor in series.

The output pin is not designed to drive speakers or anything but the smallest in-ear headphones - you'll need an audio amplifier (such as our 3.7W stereo amp) if you want to connect the amp directly to speakers. If you're connecting to a microcontroller pin, you don't need an amplifier or decoupling capacitor - connect the DC pin directly to the microcontroller ADC pin.

Weight: 0.9g
Product Dimensions: 15.8mm x 14.1mm x 2.9mm

Storage Tiers:	Maintain
Shipping weight:	0,01 kg
Item weight:	0,00 kg
Dimensions ( Length × Width × Height ):	1,58 × 1,41 × 0,29 cm
RoHS Certificate:	compliant